|
 001 Feeder motor stops, while the rest of the machine is running! 002 Feeder stops, if sheet stack falls down and the feeder crashes. 003 Problem with the synchronisation? 004 How can I check and adjust the overload clutch? 005 How to change the copper wire from 1.38 to 1.24 mm? 006 Loosing overlap! 007 The wire moves back and forth and finally the wire breaks! 008 I heard you have a new 50 pages maintenance manual with several 009 Drives switch themselves off without any actual logjam 010 Suddenly no welding, but you can still hear the current! 011 How to change belt dogs and the body transport belt! 012 Conical overlap / micro leaks! 013 How to exchange the Z-bar! 014 Undersquare canbodies are jaming before / in the tooling! 015 Folded corners / folded areas on welding edge! 016 Crash in front of the bending wedge – blank is squezzed together like 017 Strange noises coming from the helical gears on the rollformer! 018 Weak or missing vacuum? 019 How to adjust the double sheet sensor? 020 When I start production the pendulum head runs, but wire drive 021 Welding dropouts! 022 When production starts, the copper wire does not start, or only slowly! 023 Some/single welding dots are cold welded, although the seam looks very 024 The copper wire gets coloured! 025 Corrections after trimming the welding or/and pendulum roll! 026 Error message: "Can not rejected"! |
