Pacemaker™ related FAQ

001  Heatsink temperature is over 60°C!

002  CPU temperature is over 50°C!

003  “Phase voltage error” or the voltage value on the touch screen is much
         lower than on the main terminal!

004  Ths (temperature heatsink) is too low (T water)(Low Temp.)

005  Current value does not match with the adjusted value!

006  There's not enough power, the cans can't be welded properly!

007  Precharge/Preload time out! The C-bank is not reaching the necessary
         voltage within the precharge time.

008  Pacemaker Ctol or Power Limiter are not working, the display shows
         "Max....@dot.." always 0.

009  Have you instructions how to upgrade our current  Pacemaker software? Yes.

010  Cans are not welded, display shows “Phase T error”! (Old version PM)

011  Can memory is "0" but all cans are ejected!

012  No can ejection and message "Can memory overflow" in the display!

013  Error message "Wrong can ejection"?

014  Error message "Too much can ejection"?

015  Error message: " Jam in welding section"?

016  I have strange signs on the display!

017  How can I change the connection speed (baudrate)?

018  The max. value of the weldpower limiter stays 0 (zero)!

019  Eject valve/cylinder every time "ON". Counter of eject station works normal.

020  What does a flashing LED (at the reset button) mean?

021  The current shuts off after some production time, or you receive
         cans with “stitching/glueing mode”!

022  How to install a reject station?

023 Suddenly the welding current is gone (no welded cans), but no error
        message is indicated. The display shows the set current value, but
        the duty cycle is very low or 0%!

024  What's an overvoltage suppressor, is this a built in standard and
         how does it look like?

025  Overlap check!

026  Some single welding dots are cold welded, although the seam looks very
         good.

027  How to change the battery of the Pacemaker?

028  Error message: "Can not rejected"!