|
 001 What is the correct position of the calibration crown? 002 The keys on the touchscreen do not work? 003 What is the correct setting of the sucker unit (elevating platform version)? 004 Alignment problems between the pendulum roller and the lower welding 005 The wire continous to run slowly after machine control „ON“? 006 The wire moves back and forth and finally the wire breaks! 007 The profiling unit runs slowly backwards! 008 I have problems with the settings of the sensors B19, B24 and B78 009 While pushing the key „wire drive manual“, the wire tensioning cylinders 010 Laquer in the seam! 011 The machine / control is going "off" as soon as the wire starts to run 012 The last can is not welded at the end, sometimes the canbody remains 013 Undersquare canbodies are jaming before / in the tooling! 014 Error message: "Jam canbody transport"! 015 Do you have drawings with dimensions, to built my own nonstop 016 Crash in front of the bending wedge – blank is squezzed together like 017 Weak or missing vacuum? 018 Lower welding arm/welding roller get warm/hot! 019 Linmot error "overtemperature heat sink or short circuit"! 020 How to adjust the double sheet sensor? 021 How to do an insulation check on a belt driven profiling unit! 022 The canbody remains in front of the weldcenter! 023 Error: The LED "SF" and "ER" of the PLC are "red"! 024 Rollforming problems! 025 Touchscreen: all parameter are lost, but the time settings are still there! 026 Welding dropouts! 027 The copper wire gets coloured! 028 Error message: "Can not rejected"! 029 Do you have a Linmot error code list? 030 How to reset the calibration crown of the X8? |
