Bodymaking related FAQ

001  How to measure the wire correctly?                                        

002  What is the formula for the welding speed and the welding frequency?

003  What are the technical and safety specs. of the emulsion,
         Can Man is using for cooling the mercury free roller head?

004  My sheet destacker (downstacker) misses to feed body blanks
         from to time. What is to do?                    

005  How high is the welding plane, measured from the ground, on your
         welders?

006   My seam has a cold weld towards the end of the can!

007  What to do when the overlap is too big in the beginning and / or too big in
         the end of each canbody?

008  What is the "wire elongation", and how much should it be?

009  I have very irregular seams, what could be the reason?

010  Undersquare canbodies are jaming before / in the tooling!

011  What to do when the overlap is gone in the middle of the can?

012   Why can't I keep the distance from can to can constant?

013  Why is the beginning and the end of my welded canbody squeezed
         too much?

014  How to set the nosepiece height on welders with butterfly seams
         (>= 2.5mm overlap)?

016  I feel that the welding sounds unusually loud (screaming).
         What can that be?

017  What are the adjustable parameters of the welding geometry ?

018  I have too many „splattering“ in my welder. What to do?

019  How to check welding pressure assembly?

020  I have problems to keep a constant overlap. What to do?

021  I have cold welds after a couple of minutes of production and must increase
         the current. Why is that?

022  Do have you a table with the wire diameter and their corresponding
         wire width and the depth of the roller groove?

023  The copper wire grooves does not wear straight!