Alignment problems between the pendulum roller and the lower welding roller

In contrast to other machines, the roller head offset is fixed in machines of the
X- series and is therefore not adjustable.

 

If you have, due to whatever reason to adjust this setting, first make sure what the result of the offset is.

 

To adjust this offset, you have to loose the two M8 screws of the holder from the welding pressure cylinder.

 

Additionally you have to loose four M6 screws (1- two are shown), which are fixing the plate (2). Now you can shift the position of pendulum roller slightly in the various hole play.

 

NOTE:
Do not make any adjustments on this shaft!

 

Double-check the offset value again and tighten all screws securely.

 


Back