Basic settings and parameters

=> How to adjust below, see in the manual!

Transformer step:             1 (if other is chosen, mention it)

Air supply:                           min. 4 bar and dry/clean! Check if water is in the tank, if yes, please mention
it, and if the filter is still in.
It may happen that an air regulator is damaged/not working properly, due to
water or dirt.

Copper wire profile:           2.05 +/- 0.03 mm

Welding roller grooves:      width 2.10 mm, depth 0.40 mm
Edges should not be sharp, grind them manually!

Welding speed:                    See display frequency inverter, 50 – 55Hz (10 – 12m/min)
Above 12m/min micro leakages can appear!

Welding pressure:               1.7 – 2.0 bar (35-40 daN/kg)


Back