I have too many „splattering“ in my welder

  1. Change welding frequency (use Can Man PACEMAKER™)
  2. Change to another type of sheet and / or tin coating and monitor the difference.
  3. Make a „screw check“, especially of the secondary power circuit and the z-bar assembly.
  4. Use another overlap
  5. Check if any of the welding roller bearing have to much clearance (change them if so).
  6. Check the condition of the pendulum rollerhead.
  7. Check proper function of welding pressure assembly (see also „problems with welding pressure“).
  8. Check welding geometry in general.

Back
All Can Man content is now also available on the Soudronic Group website.
Where do you want to continue your journey?
All Can Man content is now also available on the Soudronic Group website.
Where do you want to continue your journey?