Problem:
PowerCURE display shows error message “E-Stop remote”
Possible Causes & Resolutions:
- One of the overcurrent motor protection relays Q27 for the fan exhaust has tripped.
Check the fans for lacquer residue. Can the fan rotate freely? Not blocked by lacquer?
- Inverter for bridging conveyor is in error state. Check the belts. Free of lacquer? Check motor.
- Inverter of conveyor is in error state. Check the conveyor belts. Check motor.
![](https://www.canman.ch/wp-content/uploads/2022/08/Frequency-inverter-and-overload-relay-suction-motors-300x224.jpg)