How to setup the HMI on a new control device

Preparing of LAN or WLAN access:

1. Connect a new PC or laptop with the Wifi of the slitter (CM_POWER_CONTROL). If you don’t have the password, contact Can Man
2. Open the network setting of that new device and set a fix IP address = 192.168.10.50 SubNet 255.255.255.0
3. Transfer the “CanMan” folder (C:CanMan) with the programs from the original windows tablet to the new device

How to start panel/HMI software:

1. Open the folder “CanMan”
2. Open the folder “Runtime”
3. Double click the file “WinGRS”
4. Now the software starts and you can use it to control the slitter

Note: Panel Software is starting in Demo mode and does work for 60min only. After that it has to be restarted. To run the HMI without time limit you need a new license or if the original panel is not in use anymore the license can be transferred with the designated form:

Setting up of a new device in case of an unserviceable device:

1. Ask Can Man for the HMI Software
2. Unzip the received file to the desktop of the windows device
3. Open the folder “CanMan”
4. Open the folder “Runtime”
5. Double click the file “WinGRS”
6. Now the software starts and you can use it to control the slitter

! Attention ! The recipe from the unserviceable device is lost.