Slitter
Feeder
Welder
Coating
Curing
Upgrades
Shop
Support
Search
Support
Category
X1 + X6
Choose another category
Keywords
Bodymaking
Calibration Crown
Canbody Guidance
Canbody Transport / Conveying
Catch Station
Control Panel / HMI
Cooling
Copper Wire
Cutting
De-/Downstacker
Drives (Motors)
Ejection
Electrical Installation M/C
Error / Error List
High Frequency Generator
Lubrication
Machine Control System
Maintenance
Parameters / Settings
Roll Former
Sheet Transport
Spare Parts (Wear Parts)
Tutorial
Water System
Welding
Welding Arm
Welding Circuit
Welding Inverter / Transformer
Welding Rollers
Welding Seam
Wire Drive
Wire Guidance
Wire Profiling
Z-Bar
Search
1
Support Entries
Error message: “Pacemaker send/receive error”
Possible cause:
Bad insulation of the G-sensor to the bracket. This can cause errors to the PM board.
Open the housing of the bracket and insulate the G-sensor properly.
see also Pacemaker FAQ
“PM send error” / “PM receive error” or welding parameter don’t match after starting the machine.
All Can Man content is now also available on the Soudronic Group website.
Where do you want to continue your journey?
stay on the Can Man website
explore the NEW WEBSITE
All Can Man content is now also available on the Soudronic Group website.
Where do you want to continue your journey?
stay on the Can Man website
explore the NEW WEBSITE
